Table T12. Acronyms and units for downhole wireline tools and measurements, Expedition 330.
| Tool | Output | Explanation | Unit |
|---|---|---|---|
| APS | Accelerator Porosity Sonde | ||
| APLC | Near array porosity (limestone calibrated) | % | |
| SIGF | Formation capture cross section (Σf) | Capture units | |
| STOF | Tool standoff (computed distance from borehole wall) | Inch | |
| DIT | Dual Induction Tool | ||
| IDPH | Deep induction resistivity | Ωm | |
| IMPH | Medium induction resistivity | Ωm | |
| SFLU | Spherically focused resistivity | Ωm | |
| DSI | Dipole Shear Sonic Imager | ||
| DTCO | Compressional wave delay time (Δt) | µs/ft | |
| DTSM | Shear wave delay time (Δt) | µs/ft | |
| DTST | Stoneley wave delay time (Δt) | µs/ft | |
| FMS | Formation MicroScanner | ||
| C1, C2 | Orthogonal hole diameters | Inch | |
| P1AZ | Pad 1 azimuth | ° | |
| Spatially oriented resistivity images of borehole wall | |||
| GPIT | General Purpose Inclinometry Tool | ||
| DEVI | Hole deviation | ° | |
| HAZI | Hole azimuth | ° | |
| Fx, Fy, Fz | Earth’s magnetic field (three orthogonal components) | Oe | |
| Ax, Ay, Az | Acceleration (three orthogonal components) | m/s2 | |
| HLDS | Hostile Environment Litho-Density Sonde | ||
| RHOM | Bulk density | g/cm3 | |
| PEFL | Photoelectric effect | b/e– | |
| LCAL | Caliper (measure of borehole diameter) | Inch | |
| DRH | Bulk density correction | g/cm3 | |
| HNGS | Hostile Environment Natural Gamma Ray Sonde | ||
| HSGR | Standard (total) gamma ray | gAPI | |
| HCGR | Computed gamma ray (HSGR minus uranium contribution) | gAPI | |
| HFK | Potassium | wt% | |
| HTHO | Thorium | ppm | |
| HURA | Uranium | ppm | |
| UBI | Ultrasonic Borehole Imager | ||
| Spatially oriented acoustic images of borehole wall | |||
| Acoustic arrival times and amplitudes | µs | ||
| Borehole diameter | Inch | ||
| Borehole azimuth | ° | ||
| GBM | Göttingen Borehole Magnetometer | ||
| Bx, By, Bz | Earth’s magnetic field (three orthogonal components) | Bits (tool coordinate system) | |
| Rx, Ry, Rz | Tool rotation | Bits (converted to degrees) | |
| Nx, Ny | Inclination/Deviation | Bits (converted to degrees) | |
| T1, T2 | Telemetry and gyro temperature | Bits (converted to °C) | |
| Fx, Fy, Fz | Magnetic field (corrected for tool rotation) | nT |
For the complete list of acronyms used in IODP and for additional information about tool physics, consult IODP-USIO Science Services, LDEO, at iodp.ldeo.columbia.edu/TOOLS_LABS/tools.html.
Previous | Close | Next | Top of page