Figure F2. Shipboard porosity results, lithologic unit boundaries (from Harris et al., 2013), and sample locations. Sample locations are marked with symbols corresponding to permeability and grain size results (solid squares) or just permeability results (open squares) listed in Table T1. A. Units I–III are described as silty clay with fine sandstone, clayey siltstone with medium to coarse sandstone, and silty claystone, respectively. B. Units I–III are described as silty clay to clay, nannofossil calcareous ooze with sponge spicules, and nannofossil ooze, respectively. C. Units I–III are described as calcareous clay with minor silt and silty clay, calcareous ooze with nannofossils and biogenic silica, and clayey siltstone with sandstone, respectively. D. Units I–III are described as silty clay with fine sand, calcareous clayey silt(stone) and minor sand(stone), and fine- to medium-grained sandstone and siltstone, respectively. E. Units I–III are described as silty clay with sand to calcareous nannofossil-rich clay, nannofossil calcareous ooze with sponge spicules, and calcareous and siliceous cemented silt- and sandstone, respectively.
Previous | Close | Next | Top of page