![]() | |||
IODP publications Expeditions Apply to sail Sample requests Site survey data Search | |||
doi:10.2204/iodp.sp.335.2010 AbstractIntegrated Ocean Drilling Program (IODP) Expedition 335 (14 April–4 June 2011) will be the fourth ocean cruise of the "Superfast" campaign to drill a deep hole into intact oceanic basement and will return to Ocean Drilling Program (ODP) Hole 1256D to deepen this scientific reference penetration a significant distance into cumulate gabbros. Cores and data recovered during the Superfast 4 expedition will provide hitherto unavailable observations that will test models of the accretion and evolution of the oceanic crust. Site 1256 was specifically located on oceanic crust that formed at a superfast spreading rate (>200 mm/y) to exploit the observed relationship between spreading rate and depth to axial low velocity zones, thought to be magma chambers, seismically imaged at active mid-ocean ridges. This was a deliberate strategy to reduce the drilling distance to gabbroic rocks because thick sequences of lavas and dikes have proved difficult to penetrate in past. ODP Leg 206 (2002) initiated operations at Site 1256, including the installation in Hole 1256D of a reentry cone with 16 inch casing inserted through the 250 m thick sedimentary cover and cemented into basement to facilitate deep drilling. The hole was then cored ~500 m into basement. IODP Expeditions 309 and 312 (2005) successfully completed the first sampling of an intact section of upper oceanic crust from lavas, through the sheeted dikes, and into the upper gabbros. Hole 1256D now penetrates >1500 meters below seafloor (mbsf) and >1250 m subbasement and currently resides in the dike–gabbro transition zone. The first gabbroic rocks were encountered at 1407 mbsf. Below this lies a ~100 m complex zone of fractionated gabbros intruded into contact metamorphosed dikes. Although previous cruises achieved the benchmark objective of reaching gabbro in intact ocean crust, critical scientific questions remain. These include the following:
Hole 1256D is poised at a depth where samples that should conclusively address these questions can be obtained, possibly with only a few hundred meters of drilling. Importantly, as of the end of Expedition 312, the hole was clear of debris and open to its full depth. Increased rates of penetration (1.2 m/h) and enhanced core recovery (>35%) in the gabbros indicate that this return to Hole 1256D could deepen the hole >300 m into plutonic rocks, past the transition from dikes to gabbro, and into a region of solely cumulate gabbroic rocks. |